Page 22: Drawing Up The Lower Thread, Sewing With A Twin Needle Drawing up the lower thread Raise the presser foot and the needle to their highest positions. Actual prices are determined by individual dealers and may vary.
The bar tacks of the buttonhole are sewn in the order shown. Loading… There is no firmware for the OS version you selected. Contact Support 1-800-OK-CANON (1-800-652-2666) Monday-Friday 10:00 am to 10:00 pm ET, excluding holidays All times ET, excluding holidays. † Prices and specifications subject to change without notice.
Remove the face plate from the machine as shown below. Always unplug the machine from the electrical outlet immediately after using it and before cleaning it. Page of 77 Please, turn your attention 2012-2016 Upload manual Thank you for your help! Page 36: Gathering, Darning Sew from the bottom of the zipper toward the top on both sides.
Keep your hands away from moving parts. ● Do not stretch or pull the fabric during sewing, otherwise the needle may be damaged and you may be injured. Lower the presser foot lever and fix the presser foot onto the shank. If the presser foot is in the correct place, the bar should snap in. Return to Top Drivers & Downloads Loading… There is no driver for the OS Version you selected.
Set the main power switch to “O”. Raise the presser foot lever and turn the balance wheel toward you (counterclockwise) to raise the thread take-up lever to its highest position. The upper thread should have caught the lower thread in a loop. Take the bobbin case out of the shuttle race by opening and pulling the latch.
Lower the presser foot and continue sewing in the new direction. ■ Finishing Sewing Stitch to the end of the seam and stop. Contract is emailed to you within hours of your purchase. While lightly holding the end of the upper thread, slowly turn the balance wheel to the front (counterclockwise) once by hand to lower, then raise the needle. Using of any other bobbin may cause damage to the machine. ● The bobbin was designed specifically for this sewing machine.
Remove the extension table and open the shuttle cover on the front of the free arm. Stop the machine when buttonhole stitching is finished. ■ Making a Buttonhole on Stretch Fabrics When sewing buttonholes on stretch fabric, the buttonhole stitching is sewn over a gimp thread. Page 42 FABRIC DOES NEEDLE NOT FEED BREAKS PROPERLY Stitch length Needle is not dial is set at no correctly inserted. feeding.
Baste the cutout to the fabric at the desired location. The driver may be included in your OS or you may not need a driver. Page 32: Making A Buttonhole (4-step Buttonhole) Lower the buttonhole lever and push it back slightly.
Название файла: 5010.pdf
Размер файла: 138 Килобайт
Количество загрузок: 1157
Количество просмотров: 297